Chevrolet Corvair 95 Series Manual page 4

IGNITION SWITCH
STARTING THE ENGINE
STARTING
LOCK OFF ON START
START-Used only when starting engine. When released,
switch returns to ON.
ON-For normal operation after engine has been started .
OFF-Turns off engine and accessories.
LOCK-Same as OFF except that switch cannot be moved
into or out of this position without ignition key .
Always switch to LOCK and remove the key when
leaving your car unattended .
NOTE:
Key cannot
be
removed from switch when in OFF
position, thus guarding against accidentally leaving
switch OFF but not locked. The key may be removed
when the switch is in ON position and the switch may
then be actuated to OFF and 5T ART positions.
3
1. AUTOMATIC TRANSMISSION-Place the transmission
shift lever in the N (neutral) position. The engine will
not start with the transmission in gear.
SYNCHROMESH TRANSMISSION - Place the trans-
mission shift lever in neutral position, and depress
clutch pedal to the floor.
2. Depress accelerator part way down and release. In
extreme cold weather
(0·
F. and below) or when en-
gine is hot, accelerator pedal should be held part
way down during starting.
3.
Turn ignition switch to START. Release ignition switch
as soon as engine starts.
4. "FLOODED" ENGINE-Fully depress the accelerator
pedal and hold in this position while cranking the
engine-do not "pump" the accelerator pedal to
correct a "flooded" condition.