Pioneer RS-P99/EW5 Service Manual page 17

5
Removing the DSP Unit (Fig.3)
1
Disconnect the five connectors.
2
Remove the two screws.
3
Straighten the tabs at eight locations
indicated and then remove the DSP Unit.
Precaution for Disconnecting/Connecting the
14P Power Cable in DSP Unit
This connector has been built to fit more tightly
than other connectors. Please use due caution
not to cause damage when disconnecting or
connecting it.
When unplugging the Coaxial Jumper, make sure to use jig GGF1539.
If the Coaxial Jumper is directly unplugged without using jig GGF1539, you might damage your fingertip or fingernail.
How to Remove the Coaxial Jumper
- -
- - When unplugging Coaxial Jumper, hook the point of jig GGF1539 on the lid of Coaxial Jumper
- - and vertically draw out along with the engagement axis of connector.
How to Attach the Coaxial Jumper
- -
- - For inserting Coaxial Jumper, adjust cord assy with the engagement axis of connector and insert it as vertically
- - as possible.
- - Do not insert the Coaxial Jumper in extreme slant, as the connector might suffer damage.
5
6
14P Power Cable
3
3
GGF1539
Coaxial Jumper
Connector
RS-P99/EW5
6
7
Coaxial Jumper
3 3
1 1 1
2
2
3 3
DSP Unit
7
8
A
1
3
1
3
B
C
D
E
Fig.3
F
17
8