Heater Sports Batter Up Instructions Manual

Advertisement

Instructions
Follow All Instructions Before Assembling Or Using This Product
IMPORTANT
DO NOT RETURN THIS PRODUCT TO THE RETAIL STORE WHERE
PURCHASED. CALL TOLL FREE: (800) 492-9334
WARNING:
Improper use of this product can result is serious injury. Read and follow the instructions
for the proper and safe use of the Batter Up. Always wear a helmet with a guard.
Adult supervision is required. Inspect the Perfect Swing, rubber bands, base, clamps, etc., before
each use for evidence of any damage. Keep the area clear with-in 24 ft. of the device and
around the swinging area of the batter. Always hit the ball toward an open unoccupied area.
Make sure all knobs and clamps are tightly and securely fastened. Never hit toward
another person. Do not use if damaged or broken.
®
95 West 650 South • St. George, Utah 84770 • PH: 800-492-9334 • PH: 435-656-1756 • Fax: 435-688-0741

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Batter Up and is the answer not in the manual?

Questions and answers

Summary of Contents for Heater Sports Batter Up

  • Page 1 Improper use of this product can result is serious injury. Read and follow the instructions for the proper and safe use of the Batter Up. Always wear a helmet with a guard. Adult supervision is required. Inspect the Perfect Swing, rubber bands, base, clamps, etc., before each use for evidence of any damage.
  • Page 2: Part List

    Part List Model# BU99 A - Large Metal Washer J - Batter Up Decal B - Center Pole K - Perfect Swing Batting Stick C - Rubber Washers (x2) L - Base I - Ground Stakes D - Base Bolt...
  • Page 3: Assembly Instructions

    Assembly Instructions Figure 1 Slide one of the Part C (Rubber Washers) over the bottom end of Part B (Center Pole). Next slide Part H (Base Insert Tube) over the bottom end of Part B. Then insert the bottom end of Part B into the top of the center hole of the Base as seen in Figure 1.
  • Page 4 Figure 5 To adjust the height of the Batter Up loosen the knob on the adjust- ment collar attached to the center pole. Then slide the adjustment collar on the B - Center Pole, into the position you desire. Figure 5.
  • Page 5 Note: Make sure to use two Rubber Bands for the necessary spring back strength. (The Batter Up comes with ten tension rubber bands, from time to time it may be necessary to replace worn or broken rubber bands. Just follow the instructions on this page to replace them as needed.)
  • Page 6 Assembly Instructions Cont. Figure 9 With the Tension Rubber Bands (Part G) attached, remove both knobs and lock washers from the “U” shaped clamp on Part B. See Figure 10. With the two knobs and lock washers removed, slide the “U” shaped side of the clamp off of the fixed side of the clamp.
  • Page 7 Keeping the wrist strap away from the swivel function. 12 - The Batter Up can be used on hard surfaces, grass and dirt. Simply remove the Rubber Stopper in the Base and fill the Batter Up with Figure 12 water, sand or cement.
  • Page 8: Instructions For Use

    Batter Up. After repeated use the Rubber Bands may become weak or break. Simply replace the worn bands when needed. Do not use the Batter Up without the necessary Rubber Bands. This may cause undue stress on the Base and Pole.

Table of Contents