Advertisement
OLYMPUS Series
Height Adjustable Key Pad Quick Guide
SETTING 4
SETTING 3
SETTING 2
SETTING 1
M
M
Initial Start Up - Calibration. (MUST BE PERFORMED AFTER ASSEMBLY)
After desk is plugged into power, follow these steps;
1. Press and hold M + UP button (at the same time) for 4 seconds.
2. Display will change to "SET"
3. Let go of M + UP button and the desk will start the calibration procedure automatically
Note: Desk will first go down to the lowest position, then up to the highest position. Once complete it will stop in between.
4. Once calibration is complete, the desk is ready to use.
Note: If desk is disassembled, moved, changed or will not go up or down, perform the above steps again.
Basic Key Pad Operation
1. Press and hold the UP
button for desired height.
Setting Quick Access Preset Height Buttons
1. Press the UP and DOWN buttons to
attain the desired height for preset
button.
Caution:
•
Saved height presets will not be lost in the event of a power outage.
•
Do not exceed recommended weight limit of 100kg (220lbs).
•
Install with 2.5cm (1") clearance around work surface to prevent finger pinch.
•
Ensure vertical motion is clear of obstruction.
QUESTIONS OR CONCERNS?
Please contact Customer Service
T 1-800-567-3060
M-F 6am - 4:30 pm PST
info@heartwoodDL.com
March 20, 2017 REV C
1 2 3 4
DISPLAY
2. Press and hold the DOWN
button for desired height.
2. Press and hold M button until you
see SET displayed.
Anti-Collision Settings
1. Press M + 3 + DOWN buttons
(at the same time) for 3 seconds.
3. Press one of the four SETTING
buttons to add as a memorized
preset desk height.
OLYMPUS
UP
DOWN
ANTI-COLLISION
ON/OFF INDICATOR
To turn ON/OFF anti-collision:
ON - LED dot in lower right corner
of display screen (as shown in
illustration)
OFF - no LED dot
Advertisement
