Mounting And Installation; Dimensions / Fastening Dimensions; En En - Larson Electronics ATEX-EHL-1123-LED-50-EPP Operating Instructions Manual

Mounting and installation

EN
7 Mounting and installation
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
7.1

Dimensions / fastening dimensions

EN
EN
Dimensional Drawings (All Dimensions in mm [inches]) - Subject to Alterations
EN
EN
EN
180 [7,09]
EN
EN
EN
EN
EN
Inspection light without wire guard
EN
EN
EN
54,50 [2,15]
Mounting bracket
8
Inspection Light LED
ATEX-EHL-1123-LED
Explosion hazard due to incorrect installation of the device!
Non-compliance results in severe or fatal injuries.
• Carry out installation strictly according to the instructions and national
safety and accident prevention regulations to maintain the explosion
protection.
• Select and install the electrical device so that explosion protection is not
affected due to external influences, i.e. pressure conditions, chemical,
mechanical, thermal and electric impact such as vibration, humidity and
corrosion (see IEC/EN 60079-14).
• The device must only be installed by trained qualified personnel who is
familiar with the relevant standards.
595 23,43 [ ]
302 11,89 [ ]
15 [0,59]
[Ø
54,50 [2,15]
0 4 9 2 6 E 0 0
Mounting bracket and
magnet
DANGER
180 [7,09]
03714E00
Inspection light with wire guard
25
Ø
0,98]
0 4 9 2 7 E 0 0
Larson Electronics, LLC.
(800) 369-6671 | sales@larsonelectronics.com
www.LarsonElectronics.com
595 23,43 [ ]
302 11,89 [ ]
04925E00