Advertisement
COMPLETE
THE INSTALLATION
(NEW CONSTRUCTION)
1. A housing mask has been provided to keep
construction dust, drywall spray, paint, etc. from
damaging heater.
Bend the flaps on the mask and push it into the
heater housing.
NOTE: Mask can be put in place before or after
heater assembly is reinstalled.
2. Remove mask before operation.
(ALL INSTALLATIONS)
3. Secure heater assembly with retaining screw and
plug wiring harness into receptacle.
4. Fasten grille to heater with two (2) screws provided.
(FIG. 13)
5. Turn on power at service entrance. Turn thermostat
to its highest setting and make sure heating element
and blower come on. Then turn it to its lowest setting
and make sure element and blower shut off.
FIG. 13
4
Advertisement
