Advertisement
Table of Contents
CLS LDC-41 GIII DMX LED DRIVER
Manual
Wall
170 gr
IP40
48 VDC
Max. 0,5 Watt
V1.0 - January 2019
www.cls-led.com
INDEX
Index
Safety information
Optional accessories
Introduction
Measurements
Lay-out description
Technical specifications
Installation
Mounting
Connect power supply
Connect LED fixture
Connect DMX
Pinning DMX output
Status display
Configuration
Menu description
Page 1: DMX addressing
Page 2: Static behaviour
Page 3: Soft dim option
Page 4: Master control configuration
Page 5: Dim curve used
Page 6: Output control
Page 7: Resolution
Page 8-11: Patch
Page 12-15: Static value
Page 16-19: Current setting configuration
Page 20: Record static value
Page 21: Firmware vesion
Page 22: Testloop
Page 23: Store configuration
Page 24: Cancel configuration
List of Symbols
2
3
3
4
4
4
4
5
5
5
5
6
6
7
7
7
8
8
8
8
8
9
9
9
9
10
10
10
10
10
10
11
www.cls-led.com
- 2 -
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CLS LDC-41
Summary of Contents for CLS LDC-41
- Page 1 INDEX CLS LDC-41 GIII DMX LED DRIVER Manual V1.0 - January 2019 Index Safety information Optional accessories Introduction Measurements Lay-out description Technical specifications Installation Mounting Connect power supply Connect LED fixture Connect DMX Pinning DMX output Status display Configuration Menu description...
-
Page 2: Safety Information
Do not stare into the LED on one driver. Unique is the DIN-rail mounting possibility of the new and small housing. The LDC-41 is equipped with a user friendly menu structure, which offers some smart solutions for installers to test & set... -
Page 3: Installation
When using the LDC-41 with a DMX controller, other than the CLS Zense you can find the connection The LDC-41 has a unique feature, it is designed to be installed on a DIN-rail. Now it is possible to install method on the side of the LDC-41. When no UTP cable is used it is adviced to use the LD-serie gender the LDC-41 directly next to the power supplies which are also suitable for DIN-rail mounting. -
Page 4: Status Display
STATUS DISPLAY The LDC-41 has a display which is used to interface with the user. When the LDC-41 is powered the DMX Page 1: DMX addressing address is showed. When DMX is active the DMX status dot is on. When no DMX the dot is flashing In this page you can adjust the DMX address of the LDC-41. - Page 5 Entering this page will result in a test loop on the Page 22: Test sequence outputs of the LDC-41. This enables the user to test the connections without the need of an DMX Press the Menu button to enter or return controller.
-
Page 6: List Of Symbols
No part of this manual may be reproduced, in any form or by any means, Colour changing Lightsource without permission in writing from CLS-LED BV. Other legal information can be found in our General conditions, found on the back of RGB, RGB-W, RGB-A, Equipped with a CLS, Citizen or a Xicato...
Need help?
Do you have a question about the LDC-41 and is the answer not in the manual?
Questions and answers