Connecting To A Garmin Vhf Comm Radio - Garmin Aera 660 Pilot's Manual

Securing the cable on the top of the yoke mount:
1) Remove the screws securing the cable clamp.
2) Orient the cable and secure the clamp with the screws.
Removing the yoke mount from the yoke shaft (or control arm):
1) Disconnect the cable connectors from the aircraft.
2) Loosen the clamp by turning the Clamp Adjustment Knob until the clamp
assembly can be easily removed from the yoke shaft or control arm.

CONNECTING TO A GARMIN VHF COMM RADIO

The aera 660 can also output frequency data to a Garmin aviation radio. For
additional information refer to the applicable installation manual. Currently the
following models are supported:
SL30 NAV/COMM
SL40 COMM
GTR 225
NOTE: For additional information refer to the SL30 NAV/COMM, SL40 COMM,
GTR 225, GNC 255, or GTR 200 installation manual.
CAUTION: This interface does not have an FAA installation airworthiness
approval. If any tuning or operational abnormalities are encountered with the
SL30 nav/comm, SL40 comm, GTR 225, GNC 255, or GTR 200, disconnect the
aera 660 from the applicable tuning interface.
190-02017-20 Rev. E
Cable Clamp
GNC 255
GTR 200
Garmin aera 660 Pilot's Guide
Appendix D
177