Troubleshooting - Wahl 9870-800 Instructions Manual

G
your jawbone and ears, cut the outer perimeter of your beard
underneath the jawbone. Continue the line all the way up to the
ears and hairline. (SEE G)
4. Accentuate your beard line by using the trimmer in a downward
motion. Start at the line you've created and, working from the chin
back toward the ears, trim the area right under your beard line.
5. Define the upper part of your beard using the same technique.

TROUBLESHOOTING

• If the trimmer unexpectedly stopped operating, try resetting the
device by plugging the trimmer into the charger.
• If your trimmer does not seem to take a charge, check the
following before returning it for repair:
1. Check outlet to make sure it is working by plugging in another
appliance.
2. Make sure the outlet simply is not connected to a light switch
which turns the power at the outlet off when lights are turned
off.
3. Be sure the trimmer is properly connected to the recharging
transformer, all connections are secure and the switch on the
trimmer is turned "OFF - 0."
4. If your electricity is connected to a master power switch, we
suggest the trimmer be disconnected from the charger anytime
the master switch is off. Leaving the unit plugged into a dead
outlet or an unplugged charger will drain the battery.
5. If trimmer does not run and it is completely charged, turn the unit
"ON - I" and pinch or push the blades manually. (Oil may have
dried out between the blades, so they may be temporarily stuck
together.)
under the chin, changing to a longer
guide toward the front of the face and
point of your chin.
3. To cut the outline of your beard, remove
the trimming guide. Starting under
your chin and working back toward
VACUUM TRIMMER
11