Table 3-1. Type Field Events; Table 3-2. Interval Field Options - VDC Display Systems MARQUEE 8521 Ultra Green User Manual

Marquee 8521 Ultra Green (HUD) User's Manual

Table 3-1. Type Field Events

EVENT
None No programmed event.
Standby On Turn Standby mode on.
Standby Off Turn Standby mode off.
Power Off Turn Power off.
channel selection Select a channel from the Channel List.
source selection Select an input.
ACON (Full) Perform an ACON (full) auto-convergence.
ACON (Touchup) Perform an ACON (touchup) auto-convergence.
ACON (Center Only) Perform an ACON (center only) auto-convergence.
Channels Up Switch to the next available channel from the Channel List.
Channels Down Switch to the prior available channel from the Channel List.
Warm up Perform a warm-up sequence:
1.
2.
3.
4.
* Only valid entries are accepted.
The Interval Field
The Interval field shows a date or interval at which the event is to take place. With the cursor positioned on the
Interval field press [ENTER] to cycle through the available options. See Table 3-2 below for details.

Table 3-2. Interval Field Options

EVENT
INTERVAL
specific date At a specific calendar date
Daily Every day.
Mon-Fri Monday through Friday.
Sat-Sun Saturday and Sunday.
Mondays Monday.
Tuesdays Tuesday.
Wednesdays Wednesday.
Thursdays Thursday.
Fridays Friday.
Saturdays Saturday.
Sundays Sunday
min./sec. interval Repeatedly at a specified time interval, in minutes
and seconds, starting at the time set in the Start
field. (Applies to Channel Up/Down events only.)
* Only valid entries are accepted.
The Start Field
The Start field shows the start time of the event. With the cursor positioned on the Start field use the number
keys to enter the start time. Use the notation previously defined by the Set Clock utility (12 hour or 24 hour). If
using a 12 hour clock, press [ENTER] to toggle between a.m. and p.m.
Note: Only valid entries are accepted. For example, if "4" is entered as the first digit of the Start time it will
not be accepted. The first digit must be either "0" or "1" when using a 12 hour clock, and "0", "1" or "2"
when using a 24 hour clock.
The Enabled Field
The Enabled field allows you to enable or disable a programmable event. When enabled, the event is performed
as programmed. When disabled, the programmed event is ignored. A check mark indicates that the event is
enabled. With the cursor positioned on the Enabled field press [ENTER] to toggle display of the check mark.
3-26
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DESCRIPTION
Turn Standby mode off (if on).
Set Contrast to 20%, Brightness to 50%, HSize to 80%,
VSize to 80% and master static focus to 100%.
Display white field for 15 min.
Restore original display settings.
ACTIVATES THE EVENT
* Use the number keys to enter the channel#.
* Use the number keys to enter
the switcher# & slot#.
ACON option is required.
ACON option is required.
ACON option is required.
Cycles back to the first channel after last
channel is selected.
Cycles to the last channel after the first
channel is selected.
Exit from warm-up occurs after 15 minutes or
when the EXIT key is pressed. Other keys
which stop warm-up are PROJ, *, UTIL, CONV
and RECALL. When warm-up stops, all
original display settings are restored.
NOTES
* Use number keys for date entry per the format defined
by the Set Clock utility.
* Use the number keys to enter minutes and seconds.
The seconds interval must be an even number, e.g.,
02, 04, 06, etc.
NOTES
Operation