Page 1
Biomet OrthoPak ® ® Non-invasive Bone Growth Stimulator System Patient Manual...
Page 2
Description of the Biomet OrthoPak ® ® Non-invasive Bone Growth Stimulator System The Biomet OrthoPak Non-invasive Bone Growth Stimulator ® ® System is a nonsurgical treatment technique designed to promote the healing of bone fractures that have failed to mend in the normal period of time.
Stimulator System device immediately after you have read the directions for use. Directions for Use: It is important that you familiarize yourself with the directions for use and the routine maintenance procedure for the Biomet ® OrthoPak Non-invasive Bone Growth Stimulator System.
System in place. It has a clip on the back which allows the patient to wear the device on their waistband or belt. Lead Wires Two different length lead wires are included with the Biomet ® OrthoPak Non-invasive Bone Growth Stimulator System.
Both battery packs provided with the Biomet OrthoPak ® ® Non-invasive Bone Growth Stimulator System are partially charged prior to being packaged. Upon receipt of the Biomet OrthoPak ® ® Non-invasive Bone Growth Stimulator System device, it is recommended that you take the second battery pack, place it into the charger, and charge fully.
Page 6
NOTE: Make sure the battery in the charger is the one supplied with your stimulator. WARNING: Do not attempt to charge any other battery. Do not use the battery packs supplied with this unit in any other device. Use of the Biomet OrthoPak Non-invasive Bone Growth Stimulator System ®...
Page 7
The green light should stay on. Otherwise check if the A/C adapter is appropriately plugged into the A/C outlet. Remove the current battery pack from the Biomet OrthoPak Non-invasive Bone Growth ® ® Stimulator System and place that battery pack in the charger cradle for charging. Open the...
Page 8
Consult your local Biomet representative should you have questions about your electrode placement. Make sure you apply the electrodes after your skin has been cleaned and dried.
Loose Electrodes - Make sure that both electrodes are in complete contact with your skin. Moisten or replace worn electrodes if necessary. Incomplete Circuit - Check all connection points, insuring tight fit of lead wire plug into the Biomet OrthoPak Non-invasive Bone ®...
Page 10
Non-invasive Bone Growth Stimulator ® ® System display will indicate the symbol for low battery charge. (P. 10) With the audio alarm engaged, beeping will occur. 2. Only after inserting a charged battery pack into the Biomet ® OrthoPak Non-invasive Bone Growth Stimulator System will ® the message read . (P. 10)
Page 11
Check all lead wire connection points, to make sure that the electrode lead wire is tightly plugged into the top of the Biomet ® OrthoPak Non-invasive Bone Growth Stimulator System (See ®...
Page 12
“ON” as soon as possible by pressing the button for 3 seconds again. • During an alarm condition, depressing the button quickly (0.5 seconds) will temporarily disable the audible alarm. Figure 8 • R emove your Biomet OrthoPak Non-invasive Bone Growth ® ® Stimulator System when you bathe, shower or swim. You should...
IMPORTANT: All medical questions must be directed to your doctor. Ordering Information To order supplies, simply contact Biomet directly. The following information is necessary to expedite any requests: • Patient name • Physician name...
Page 14
Components in this system are to be used only with Biomet approved parts. No attempt should be made to modify or repair this device.
Page 15
Adverse Events NOTE: With the exception of the following, no known adverse effects have resulted from the use of this device: General tissue sensitivity at the skin/electrode site with unknown specific etiology may occur. This tissue sensitivity may be caused by the electrode gel, excess perspiration or a combination of both.
Need help?
Do you have a question about the OrthoPak and is the answer not in the manual?
Questions and answers