Table of Contents
Advertisement
1. INSTALLATION
The CH140GSM programmable thermostat is to be wall-mounted or installed on a
recessed box, with 3 modules or round, at a height of about 1.5 m from the ground.
PERFORM THE FOLLOWING STEPS:
1. Disconnect the power to the electrical system by actuating the main switch of the electrical
panel
2. Separate the rear baseboard from the body of the programmable thermostat by using a tool
on the relevant slot (see Figure 1)
3. Remove the insulation protection on the baseboard by unscrewing the specific captive screw.
4. Make the electrical connections as shown on page 5.
5. Secure the baseboard to the wall or to the recessed box, using the screws supplied.
6. Reposition the insulation protection by tightening the screw.
7. Open the SIM-holder compartment at the back of the programmable thermostat, as shown
in Figure 2.
8. Insert a SIM* (NOTE pag. 4), complying with the direction shown in Figure 3 (see pag. 4) and
close and tighten the flap of the SIM-holder.
9. Press the body of the CH140GSM to the baseboard secured to the wall and couple.
10. Restore the power of the electrical system.
Figure 1
Figure 3
push
to release
Figure 2
Intellicomfort
CH140GSM
3
Advertisement
Table of Contents
