Advertisement
7. I need to make a change to device(s) or the way the cables were setup.
Open your Harmony Express App
Go to Edit Setup
8. I am getting an error message on the Harmony Express app while I am in
Setup. Check for the following:
blaster is plugged in
remote is plugged in and being charged
unplug and replug in the blaster try again after 30 seconds
force close the Harmony Express app and re-launch the app
verify if your mobile device is connected to Wifi and Internet
9. My remote is not working
Check for the following:
if the light ring is blinking red, the remote needs to be charged until it turns
solid white, however while plugged in the remote can be operational
If the blaster is displaying red, go to the Harmony Express App............
unplug and replug in the blaster try again after 30 seconds
10.
Voice commands are not working or I am getting an error
message from the remote.
Use the Harmony Express Insert Card to see for voice commands that
should work
Unplug and plug in the blaster and try again after 30 seconds
????
15
Advertisement
