Fidelis Network CommandPost/K2 Quick Start Manual page 3

CommandPost/K2 Setup Checklist
Check Fidelis Network Sensor – Appliance Requirements
Appropriate rack space, power, and cooling
Rack tools, rails, and connectors
Keyboard and video monitor / KVM switch for temporary appliance setup
Power cables — two per appliance, appropriate for power source and region
Ethernet cables (cat5 and optical) for Admin and iLO ports
Network switches with enough physical ports
Logical network information: IP addresses, hostnames
3. CommandPost/K2: Network Port and Cabling
Requirements
Each appliance must be connected to the various networks with appropriate cables and (in some
cases) transceivers. The tables below describe the physical connection and cable type associated
with each port on the appliance.
CommandPost/K2 Appliance
Port Label
Admin
iLO
©Fidelis Cybersecurity
Physical Connection Type (default)
GbE RJ45 (copper)
GbE RJ45 (copper)
Figure 2: CommandPost/K2 Rear Port Assignments (Rev-I)
Fidelis Network® CommandPost/K2
(Appendix B)
(Section
(Section 4)
(Section
3
QUICK START GUIDE
3)
5, Appendix A)
Cable Type (minimum)
Cat 5 patch cable
Cat 5 patch cable
www.fidelissecurity.com