How To Operate; Power Connection9; Sensor Connection; Input High Level Voltage - dacell DN-AM210 User Manual

4. How to operate

4-1. Power connection
○ Please only use the exclusive AC code (5-tube) for the power cord. When AC
1
is not grounded, please make the connection by using the ground connector
which is located on the backside of lamp.
○ Please check the AC power selecting switch and then supply power to the
2
device. If the lamp is not lighted, please check the fuse and power selecting
switch.

4-2. Sensor connection

4-3. High Level Voltage Input
This device can measure the signal that inputted in DC (DCDT, High level,
Thermocouple etc).
For the measurement, following conditions should be satisfied.
On Common mode, the amp input should be as  10V. Please be careful since
○
1
when over  10V is inputted, the signal source will be cut off.
4 Gauge
Full Bridge Connection
Transducer
8