Advertisement
Available languages
Available languages
8.) Remove the stainless steel
fire pot from the fountain;
when using paraffin fuel
make sure the supplied
wick is pushed to the
bottom of the fire pot
using the supplied wick
ring to prevent the wick
from floating.
9.) Fill the fire pot with paraffin
fuel (not included) to
the top of the wick. A
full fire pot will burn for
approximately 1 to 1.5 hours.
9
10.) Place the fire pot back into the appropriate location in
the Fire Pot Holder.
10
71153.11265
6
8
For more information about our company or products, please visit our website at
www.aquascapeinc.com or call us at (US) 1-866-877-6637 (CAN) 1-866-766-3426
©2014 Aquascape, Inc. • All Worldwide Rights Reserved
☎
US 1-866-877-6637 |
11.) Plug the pump in a
GFCI rated receptacle.
12.) Light the wick with a
long handled match
or long handled lighter,
do not use a small lighter
or compressed gas
lighting source.
12
13.) Enjoy your new Aquascape Fire Fountain.
Electrical Requirements & Precautions
• Do not locate lighting fixtures directly above the fountain.
• Lighting and electrical receptacles must be located at least
5 feet from the fountain. Lighting and electrical receptacles
located between 5 and 10 feet from the fountain must be
on a circuit protected by a GFCI.
Regular Maintenance
• Remove leaves, sticks and debris from the Fire Fountain
before use.
• Drain the fountain of dirty water and refill it with fresh clean
water when necessary.
• Clean the pump filters periodically or if pump flow slows.
• Do not allow the pump to run dry, this could damage the
pump and void the pump warranty
• Place Fire Pot Cover on pot when not in use to avoid water
getting in Fire Pot.
☎
CAN 1-866-766-3426 | www.aquascapeinc.com
11
Advertisement
