ICWUSA.com, Inc.
VTTM Tandem arm
Uses Ball VESA
VTTM onlY - aTTaCH aRMs
4 screws on each side
.25-20x.625
Loosen factory installed
screw in each side of
arm assembly. Rotate
arms into position as
shown. Tighten existing
screw. Insert 3 additional
screws into both short
ears. Tighten.
VT & VTlP - MoUnT Main assEMBlY
Page 1 of 5
Page 1
VT21 insTallaTion
VT
Uses Ball VESA
VTTM onlY - aTTaCH MoUnTinG PlaTE
To attach main unit
to arm assembly,
insert .25-20x1.25
flat head screws
through top and
bottom holes of
front of main
assembly into
mounting plate.
Insert three .25-
20x.25 button head
screws in center
holes through front
of main unit. Tighten
screws.
Locate the wall stud and mark
the top hole. Using a level,
mark the lower hole. Drill 11/64
pilot holes and insert #14
screws through the front of
main assembly and tighten.
NOTE: #14 Wood screws are
supplied with unit. If installing
into metal studs, you will
need to replace these with
proper metal stud fasteners. All
hardware used to secure track
mount must have a proper
countersunk head.
If you have any questions, please call 1-800-558-4435
VTlP low Profile
Uses Flat VESA
Button
head
screws
all MoDEls - aTTaCH FaCE PlaTE
Attach face plate to
slider assembly with
.25-20x1.25 flat head
screws.
VT21 INSTALLATION - rev 10/6/15 pjm
VIDEO: Installation
https://youtu.be/PJwD1749kQc
VIDEO: Wire management
https://youtu.be/wBgJh0AiDMI
All models are available with
Flip-up keyboard Tray or
Worksurface Tray.
MAXIMUM LOAD CAPACITY
10- 25 Lbs (4.5-11.3 kg)
VTTM onlY-
MoUnTinG
To Wall oR
Wall TRaCK
Instructions
on page 4
Mounting
plate