Related Manuals for MERIT INDUSTRIES Megatouch FORCE Fusion
Summary of Contents for MERIT INDUSTRIES Megatouch FORCE Fusion
- Page 1 Megatouch FORCE Fusion Monitor Replacement Visit the Merit Industries, Inc. Web site http://www.meritind.com merit industries, inc. PM0450-03...
- Page 2 COPYRIGHT © 2004 MERIT INDUSTRIES, INC. Megatouch FORCE Fusion Monitor Replacement CONTENTS: PART NUMBER DESCRIPTION LCD MONITOR W/ SIDE BRACKETS, SA0469-03 TOUCHSCREEN SA0469-04 LCD MONITOR W/ SIDE BRACKETS ONLY SB0016-01 TOUCHSCREEN TAPE KIT SA0469-09 LCD MONITOR W/ TOUCHSCREEN EC9384-02 LCD MONITOR ONLY...
- Page 3 LCD panel (see Figure monitors only: Also disconnect the 3). Clean the front of the touchscreen monitor control board connector. See with the supplied alcohol wipe once it Figure 3. is in place. MEGATOUCH FORCE FUSION MONIT OR REPLACEMENT PM0450-03...
- Page 4 COPYRIGHT © 2004 MERIT INDUSTRIES, INC. Reinstall the bezel on the game and When the game is finished booting, fasten it with the 6 thumbnuts. press the CALIBRATE button. Plug in and turn on the game. Close and lock the bezel, then cali- brate the touchscreen.
- Page 5 After disconnecting the ground screw, pull the cables out of the clamps. See Figures 6 and 7. MEGATOUCH FORCE FUSION MONIT OR REPLACEMENT PM0450-03...
- Page 6 COPYRIGHT © 2004 MERIT INDUSTRIES, INC. If you will not be reusing the existing mounting frame with the larger, drilled touchscreen, skip to the next step. If holes on the plastic mounting pieces you will be reusing the touchscreen, (see Figure 9), and fasten it with the note the orientation of the screen (i.e.,...
- Page 7 FIGURE 5 - FUSION WITHOUT ELECTRONICS BOX - UNDERSIDE OF BEZEL TOUCHSCREEN CONTROLLER CONNECTED TO LCD PANEL SCREWS FASTENING CONTROLLER TO GAME (2 PLACES) FIGURE 6 - FUSION WITHOUT ELECTRONICS BOX - TOUCHSCREEN CONTROLLER MOUNTED ON BEZEL MEGATOUCH FORCE FUSION MONIT OR REPLACEMENT PM0450-03...
- Page 8 MOLEX CONNECTOR GROUND SCREW FIGURE 7 - FUSION WITHOUT ELECTRONICS BOX - CLOSEUP OF CPU SECTION CABLE CLAMPS SCREWS FASTENING LCD MONITOR TO BEZEL (10 PLACES) FIGURE 8 - FUSION WITHOUT ELECTRONICS BOX - UNDERSIDE OF MONITOR PM0450-03 MEGA TOUCH FORCE FUSION MONIT OR REPLACEMENT...
- Page 9 COPYRIGHT © 2004 MERIT INDUSTRIES, INC. DRILLED HOLES (5 PER SIDE) FIGURE 9 - FUSION WITHOUT ELECTRONICS BOX - PLASTIC MOUNTING PIECES ON BEZEL MEGATOUCH FORCE FUSION MONIT OR REPLACEMENT PM0450-03...
- Page 10 MEGATOUCH FORCE FUSION MONITOR REPLACEMENT PM0450-03...
Need help?
Do you have a question about the Megatouch FORCE Fusion and is the answer not in the manual?
Questions and answers