1
2
3
Figure 3
1. Bolt (5/16 x 3/4 inch)
2. Hood-cable-guide bracket
3. Secure the ROPS-cable-guide bracket using 1 U-bolt (4
inches), 4 spacers, and 2 locknuts (3/8 inch) as shown
in Figure 6.
Figure 4
1. ROPS-cable-guide
bracket
2. U-bolt
g022154
3. Nut (5/16 inch)
3. Spacers
4. Locknut (3/8 inch)
Installing the Cable Guides for the
ProSneak 365
1. Open the right or left side panels of the machine hood.
2. Remove the existing bolts and nuts between the front
nose cone and the center strip.
Note: Do not discard the nuts.
3. Secure the bent cable-guide bracket between the center
strip and the front nose cone using 2 bolts (5/16 x 1
inch) and the 2 nuts previously removed (Figure 5).
2
1
1. Nuts
2. Bracket
4. Secure the ROPS-cable-guide bracket using 1 U-bolt (4
inches), 2 spacers, and 2 locknuts (3/8 inch) as shown
in Figure 6.
g026714
1. Locknut
2. Spacer
3
3
Figure 5
3. Bolts
Figure 6
3. ROPS-cable-guide
bracket
4. U-bolt
g026715