Summary of Contents for Acura 08E90-T6N-200-01
- Page 1 Acura NSX ©2018 Honda Motor Co., Ltd — All rights reserved. BAM03342-07...
- Page 2 12V BATTERY CHARGER USER’S INFORMATION MANUAL...
-
Page 3: Introduction
This product is designed to be used exclusively on an Acura NSX. Acura is not responsible if the product is used for anything other than its intended purpose. -
Page 4: Table Of Contents
Content Introduction ......................................2 Parts / Important Notices..................................4 Installation Instructions ..................................5 Charging ........................................6 Battery Charger Operating Cycles ..............................7 Charge Port Indicator ...................................8 Maintenance Instructions / Troubleshooting ...........................9 How to check and Change Fuse ................................10 Usage Guidelines ....................................11 Important Safety Precautions ................................12 Technical Specifications ..................................13... -
Page 5: Parts / Important Notices
PARTS IMPORTANT NOTICES This product is a switch mode charger with both float and pulse CALIFORNIA PROPOSITION 65 maintenance and represents the latest in battery charging WARNING: This product contains chemicals known to the state of technology. Proper use of this product can help maximize the life of California to cause cancer or reproductive toxicity. -
Page 6: Installation Instructions
INSTALLATION INSTRUCTIONS 2. Connect the AC connector to household 2 prong AC outlet. 1. Connect the charger to the charge port inside the vehicle first. CHARGE PORT OUTLET BATTERY CONNECTOR CHARGER CORD CHARGE PORT CONNECTOR REMOVAL INSTRUCTIONS First unplug the battery charger AC connector, and then unplug the BATTERY charge port connector. -
Page 7: Charging
CHARGING STEP 1: DESULPHATION Detects sulphated batteries. Pulsing current and voltage removes Indication Description sulphate from the lead plates of the battery restoring the battery capacity. Error mode STEP 2: SOFT START Desulphation Tests if the battery can accept a charge. This step prevents charging a Soft start defective battery. -
Page 8: Battery Charger Operating Cycles
BATTERY CHARGER OPERATING CYCLES DESULPHATION SOFT START BULK ABSORPTION ANALYSE FLOAT PULSE 15.8V 4.3A until Increasing Declining Checks if 13.6V 12.7V–14.4V 12.6V voltage to current. 14.4V voltage drops 4.3A 4.3–2A 14.4V. 4.3A to 12V 10 days. Charge cycle Charge cycle Limit: Max 8h Max 8h... -
Page 9: Charge Port Indicator
CHARGE PORT INDICATOR The charge port has a red LED that will flash to indicate a low voltage condition in the 12V battery. The LED will begin flashing any time the battery voltage drops below 12.4 volts. -
Page 10: Maintenance Instructions / Troubleshooting
MAINTENANCE INSTRUCTIONS TROUBLESHOOTING This product is maintenance-free. The charger must not be opened; If the error lamp is lit, check the following: doing so will void the warranty and incorrect reassembly may result 1. Is the charger connected to the charge port? in a risk of electrical shock or fire. -
Page 11: How To Check And Change Fuse
HOW TO CHECK AND CHANGE FUSE 2. The fuse for the charge port is located in the subfuse box shown here. 1. Remove the passenger’s under cover, as shown. FRONT VIEW 3 CLIPS PASSENGER’S UNDER COVER SUBFUSE BOX 10A FUSE CONNECTING LOCATION... -
Page 12: Usage Guidelines
USAGE GUIDELINES • Avoid covering the charger during use. • Do not place the charger on top of the battery when charging. If an extension cord must be used, make sure that the extension cord is in safe working order and has the proper wire size as shown below. • Do not operate charger if it has received a sharp blow or been Use of improper extension cord could result in a risk of fire or dropped. -
Page 13: Important Safety Precautions
IMPORTANT SAFETY PRECAUTIONS • If the charger fails to reach Step 6 within 50 hours, it will enter WARNING an error mode where battery charging stops. The battery charger The battery gives off explosive hydrogen gas during normal operation. should be disconnected if this error mode is entered. Working in the vicinity of a lead-acid battery is dangerous. -
Page 14: Technical Specifications
** The quality of the charging voltage and charging current is very important. A high current ripple heats up the battery which has an aging effect on the positive electrode. High voltage ripples could harm other equipment that is connected to the battery. Acura battery chargers...