Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for OHAUS 83021082
Summary of Contents for OHAUS 83021082
- Page 1 ® Explorer Balance Ethernet Interface Option Kit Installation Instructions...
-
Page 3: Kit Contents
Balance Ethernet Option Interface Kit EN-1 1. INTRODUCTION The Ethernet Interface Option Kit provides a standard Ethernet interface for Ohaus Explorer Series Balances. Please read this manual completely before installation and operation. CAUTION: READ ALL SAFETY WARNINGS BEFORE INSTALLING, MAKING CONNECTIONS, OR SERVICING. FAILURE TO COMPLY WITH THESE WARNINGS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE. -
Page 4: Safety Precautions
® EN-2 Explorer Balance Ethernet Option Interface Kit 2. INSTALLATION 2.1 Safety Precautions For safe and dependable operation of this equipment, please comply with all safety precautions mentioned in this manual. Note: Disconnect the equipment from the mains power supply before beginning installation. - Page 5 ® Explorer Balance Ethernet Option Interface Kit EN-3 Open the Display: press button (enlarged in photo), then lift Display until it disengages. Unplug Display Communication Cable, if desired, for greater freedom of movement. To release the clip that secures the Display Communication Cable: press out on both sides, as shown, then unplug the Display...
- Page 6 ® EN-4 Explorer Balance Ethernet Option Interface Kit Remove the two screws holding the Option faceplate using a screw- driver. Remove this plate. Save the screws, they will be used to install the new RS232 interface board. Note: Do not touch any items inside the Display.
- Page 7 ® Explorer Balance Ethernet Option Interface Kit EN-5 Route the RS232 Cable out either: 1. Under the Base and out the Back, as shown at left; or… 2. Out the side of the Display, through the groove near the release button (either side), as shown here.
-
Page 8: Operation
® EN-6 Explorer Balance Ethernet Option Interface Kit 3. OPERATION Using the Ethernet Port to connect to a Local Area Network After successful installation of the Ethernet Interface Option, the Ethernet appears as an option on the Communication Menu. Press Ethernet to see options for Device Settings and Print Settings. - Page 9 ® Explorer Balance Ethernet Option Interface Kit EN-7 The Port setting cannot be changed. Press IP Address to change the setting. Press Default Gateway to change the setting. Press Subnet Mask to change the setting.
-
Page 10: Maintenance
4.1 SERVICE INFORMATION For Service assistance in the United States, call toll-free 1-800-526-0659 between 8:00 AM and 5:00 PM Eastern Standard Time. An Ohaus Product Service Specialist will be available to assist you. Outside the USA, please visit our website, www.ohaus.com, to locate the Ohaus office nearest you. - Page 12 Ohaus Corporation 7 Campus Drive Suite 310 Parsippany, NJ 07054, USA Tel: (973) 377-9000 Fax: (973) 593-0359 With offices worldwide. www.ohaus.com *83021183* P/N 83021183A © 2016 Ohaus Corporation, all rights reserved. Printed in China...