Dyson Airblade Series Installation Instructions Manual page 236

Installation instructions
US
READ AND SAVE THESE
INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
BEFORE INSTALLING OR USING THIS MACHINE READ ALL
INSTRUCTIONS AND CAUTIONARY MARKINGS IN THE
INSTALLATION INSTRUCTIONS AND MAINTENANCE MANUAL.
When using an electrical machine, basic precautions should always
be followed, including the following:
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
1. Use this machine only in the manner intended by
the manufacturer. If you have any questions, contact
the manufacturer.
2. Before servicing or cleaning the machine, switch the power
off at the service panel. Ensure the switch is locked to prevent
the power from being switched on accidentally. If the means
of switching off the power cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable codes and
standards, including fire-rated construction.
4. When cutting or drilling into a wall or ceiling, do not damage
electrical wiring and other hidden utilities.
5. Do not use sealant when fixing the machine to the wall.
6. Do not install directly above a heating appliance.
7. The size of the lead wire used for the wiring connection
(including grounding lead) shall not be smaller than 18AWG.
DO NOT USE ANY JETWASH OR POWER WASHING EQUIPMENT
FOR CLEANING ON OR NEAR THIS MACHINE.
WARNING
ALL ELECTRICAL INSTALLATION AND REPAIR WORK SHOULD
BE CARRIED OUT BY A QUALIFIED ELECTRICIAN OR DYSON
FIELD SERVICE TECHNICIAN IN ACCORDANCE WITH CURRENT
LOCAL CODES OR REGULATIONS.
CAUTION
Your hand dryer should be located indoors. Operating temperature
range 32°F (0°C) to 104°F (40°C). To reduce the risk of fire or
electric shock, do not expose the internal mechanisms/components
of this machine to moisture.
236