SAAS Muscle Series Installation Instructions

SINCE 1954
SAAS Automotive PTY LTD
25 Metrolink Circuit West Campbellfield
Victoria 3061 Australia
ABN: 48166279670 ACN: 166279670
Phone: +61 3 9930 0100
Fax: +61 3 8339 2270
Email: tech@saasautomotive.com.au
Important notes before installing:
- Installing this product to your vehicle may require an adaptor. SAAS make a large range of
adaptors and installation parts, please check with your SAAS dealer for available adaptors.
- SAAS Muscle series gauges are designed for 12volt systems ONLY!
- All installation work should be done by a qualified professional to avoid damage to this product.
- SAAS RECOMMENDS all products be tested prior to installation. This will save time and speed up
the troubleshooting process if you encounter any issues.
Wire colour
Red
Blue
Black
Yellow
- Red wire must be connected to the (+) terminal of the vehicles battery.
- Blue wire connects to (+) side of fan/fans with a current draw no more than 35 AMPS!
- Black wire must be connected to a good grounding point, usually the vehicles body/chassis.
- Yellow wire must have 12V+ power when the ignition is in the ON position.
COOLING FAN CONTROLLER
SET LIGHT
DIGITAL COOLING FAN CONTROLLER
Installation Instructions
Wiring Guide:
Wire Function
Battery 12V+
Fan 12V+ output
Ground 12V-
Ignition 12V+
Fan Controller Functions:
Set: This button is used to set the temperature for controlling
UP DOWN
Wire Connection Location
(+) terminal of battery
To fan/fans (+) side
Vehicle body
Ignition harness / Fuse box
your fan/fans.
Light: Press this button to change the back lighting
colour. (white>red>green>blue)
Up: This button is used to increase the temperature
preset.
Down: This button is used to decrease the temperature
preset.
Page 1/4