Advertisement
Soft Close Drawers
When a cabinet has soft close drawers, the drawers will need to be removed prior to installation of the cabinet.
Please view the following instructions on how to remove the drawers.
Removal
When you pull the drawer out you will notice a grey label on each side of the drawer (as per below diagram).
When the label on each side is removed – it will reveal a small lever on each side of the drawer. Both levers
are to be pulled up at the same time, then slide the drawer out slowly towards you.
Remove cover cap
Drawer re-installation
Push runners into cabinet, place drawer body on runners and push in firmly. Two clicks should be heard as drawer
sides click into place. Replace drawer front as per reverse of diagram above.
Engaging the soft-close mechanism
Put the drawer back in half way – close the drawer. Then pull the drawer back towards you. Underneath the
drawer you will feel a small tab. This is on each side of the drawer. Pull the tab towards you and at the same time
push the front of the drawer back. This will engage the soft close mechanism.
Adjustment
Check the unit is square on the wall before making adjustments.
Adjust drawer rails to ensure top and bottom drawer face align giving a flush close.
Clockwise = in, anticlockwise = out.
Left/Right Adjustment
Release drawer from the slide, pull out the drawer
(Failure to do this will damage the drawer running mechanism)
Height Adjustment
P re s s -in
Fit cover caps
3
Advertisement
