Cleaning Before First Use - Instant ACE NOVA User Manual

Cleaning Before First Use

Before using the Instant Ace Nova for the first time, follow the steps below to clean
the pitcher.
1. Connect the power cord to a 120 V power source.
Note: The display is blank until the pitcher is seated on the blender base and the lid is
fully secured.
2. Remove the lid and fill the pitcher with hot water to 32 oz / 1000 ml, as
indicated on the pitcher.
3. Place the lid on the pitcher and press down firmly, then turn the lid clockwise
until it clicks into place.
The lid braces (located on the sides of the lid) must fit over the glass lid-brace
catches (located on the pitcher).
4. Place the pitcher on the blender base by aligning the
near the bottom of the pitcher to the
blender base.
The display indicates OFF when the pitcher is seated correctly.
Note: The blender will not start until the pitcher is properly seated and the lid is locked
in place.
5. Turn the lid cap counter-clockwise, then remove the lid cap from the lid.
6. Add a minimal amount (1-2 drops) of dish soap to the pitcher.
Too much dish soap may result in excess foam, which can cause the pitcher to
overflow.
7. Fit the lid cap into the hole in the lid, then turn the lid cap clockwise until it
clicks into place.
8. Press Clean to select the cleaning function.
9. Press Start/Pause to begin.
Note: Do not reach into the pitcher while the blender is in use. Rotating blades can
cause damage and serious injury. Do not put hands, spatulas, or any other utensil into
the pitcher while the blender is running.
10. When the program completes, the display indicates End.
11. Lift the pitcher up and off the blender base.
When the pitcher is removed from the blender base, the display dims.
12. Remove the lid and discard the soapy water. Rinse the pitcher, lid and lid cap
with warm, clear water.
Ensure the bottom of the pitcher remains dry.
You're ready to start using your Instant Ace Nova!
NOTICE
If you are not ready to start blending, allow the pitcher to air dry fully before storing.
16
position indicator near the top of the
position indicator