Important Safeguards To guard against injury, basic safety precautions 10. If an extension cable is used it should have the should be observed, including the following: proper rating. Care should be taken to arrange the cord so that it will not be tripped or pulled. 1.
Replacement Parts & Filter Media AquaFill Impeller Use Aqua One Genuine Spare Parts Only. See your local Aqua One Dealer and look for the number listed below for the spare part you require. Alternatively you will find these numbers on the silver label located...
Installation Follow the diagram below to set up the AquaFill system. 8. Connect the pump to the control box using the socket labelled “pump”. Connect the supplied power supply to the socket labelled “power in” using the supplied male- male power cable.
Operation Pump Maintenance When operating, the AquaFill pump will switch on Clean the impeller at least once a month. when the water level falls below BOTH primary and secondary float switches. 1. Switch off the power to the top-up unit.
Trouble Shooting Specifications SUMP WATER LEVEL IS LOW AND NOT FILLING Model: AquaFill Maximum Flow Rate: 200L/hr 1. Ensure reservoir is full. Max Head Height: 0.5m Power Requirements: 12V AC 2. Ensure all power connections are securely plugged Power Consumption: 3.5W...
Page 7
1.0. Terms and Conditions of Guarantee. 1.1. Aqua One warrants to the purchaser, for 1 Year from date of original purchase, to repair or replace goods where fault is found due to defective materials or faulty workmanship and where goods do not operate in accordance with the instructions.