Advertisement
IMPORTANT: Do not open the lid while the blender is working.
CONTROL SETTINGS
1 -
Low Speed. Will blend continuously on Low speed until you return the switch to the off position.
2 -
High Speed. Will blend continuously on High speed until you return the switch to the off position.
0 -
Off. Will turn off the unit.
ICE CRUSH -
To use this setting hold the button in for a few seconds, then release, repeat this process until
your ice is at the desired consistency.
PULSE -
The pulse setting will operate at the highest speed, and will only operate when you are holding
the switch, as soon as you release the switch the appliance will stop. This is suitable for when you
only want to roughly blend ingredients and you require control so that you don't end up with a
really fine mixture.
7. Turn the dial to the "OFF" position when you have finished. Wait for the blender to completely stop. Unplug
the appliance before removing the lid or the jug.
8. Always ensure the appliance is unplugged after use.
NOTE: It is recommended to cut the meat, vegetables or other food into smaller pieces before putting them in the
jug. Large quantities of food should be processed in small batches, do not overload. Do not operate the blend-
er continuously for more than 1 minute. Always allow the appliance to cool down to room temperature before
continuing.
WARNING: ALWAYS COOL HOT LIQUIDS BEFORE BLENDING.
NOTE: If blending warm liquids remove the measuring cap and start at low speed increasing to high speed if
required. The pulse setting is not recommended for warm liquids. Do not blend warm liquids over the 1L level,
and always take care to avoid contact with any steam or liquids.
USING THE GRINDING ATTACHMENT
1. Make sure the unit is unplugged and turned off before installation of the grinder attachment.
2. The grinder can be used for coffee beans, dried herbs, bread crumbs etc.
3. Turn grinder upside down and carefully unscrew the blade housing. Carefully remove the blade housing.
4. Fill the grinder with desired ingredients. Do not fill more than half full.
5. Screw the blade housing tightly on to the bowl.
6. Turn the grinder the right way up and place on the motor unit.
7. Plug the appliance in and select desired speed setting. Apply a small amount of pressure to the top of the
grinding bowl, to ensure the safety switch is activated.
8. When the ingredients have been ground/chopped to the desired consistency, unplug the appliance, and re-
move the grinding unit from the appliance.
NOTE: Always unplug and remove the complete grinding unit. Do not unscrew the glass bowl on the unit. As this
will cause the ingredients to spill out and expose the blade unit.
9. Turn the grinder upside down and carefully unscrew the blade housing. Carefully remove the blade housing
Advertisement
