Stihl FH Instruction Manual page 6

Wear an approved safety
hard hat to reduce the risk
of injury to your head
when there is a danger of
head injuries.
STIHL offers a wide range of protective
clothing and equipment.
THE POWER TOOL
For illustrations and definitions of the
attachment parts see the chapter on
"Main Parts."
!
Warning!
Never make any unauthorized
modifications to this power tool. Only
attachments supplied by STIHL or
expressly approved by STIHL for use
with the specific STIHL model are
authorized. Although certain
unauthorized attachments are useable
with STIHL power tools, their use may, in
fact, be extremely dangerous.
If this tool is subjected to unusually high
loads for which it was not designed (e.g.
heavy impact or a fall), always check
that it is in good condition before
continuing work. Check in particular that
the fuel system is tight (no leaks) and
that the controls and safety devices are
working properly. Do not continue
operating this machine if it is damaged.
In case of doubt, have it checked by your
STIHL servicing dealer.
FH
THE USE OF THE POWER TOOL
Transporting the Power Tool
!
Warning!
To reduce the risk of injury from blade
contact, never carry or transport your
power tool with the cutter blades
moving.
It may be carried only in a horizontal
position. Grip the shaft in a manner that
the machine is balanced horizontally.
Keep the hot muffler away from your
body and the cutting attachment behind
you.
English / USA
!
Warning!
Always switch off the engine and fit the
scabbard over the cutter blades before
transporting the power tool over long
distances. When transporting it in a
vehicle, properly secure it to prevent
turnover, fuel spillage and damage to the
unit.
On machines with an adjustable cutter
bar: Make sure the cutter bar is secured
in position. See chapter in this
instruction manual entitled "Adjusting
Cutter Bar Angle." On machines with a
transport position: Move cutter bar to
transport position and secure.
Before Starting
!
Warning!
Always check your attachment for
proper condition and operation before
starting. Never attempt to modify the
controls or safety devices.
5