Danfoss Link HP-kit Installation Instructions Manual page 3

Installation manual
Note the following when installing the Danfoss Link
• Installation and positioning must be done in accordance with applicable laws and regulations.
• The Danfoss Link
ware version 1.34 or later, and DHP-AQ with software version 2.2 or later. The Danfoss Link
suitable for heat pumps with a cooling function (DHP-C and heat pumps with a cooling module).
Quick Installation Guide
1
3
Create rooms and add battery-powered
units one at a time
Tip!
• The ? key on the Danfoss Link™ CC panel can be used at any time during installation.
• Always check for the latest software version at www.link.danfoss.com before installation. See the section on software
upgrades in the Danfoss Link™ CC Installation Manual.
3
Danfoss Link™ HP kit
™
HP kit only works in conjunction with heat pumps DHP-H/L/A 2009 or later, using soft-
Install the components of
the Danfoss Link™ HP kit
^
^
VIIFR102
™
HP kit:
2
Install all mains powered units
first and add them to the network
4
Perform the network test with the Dan-
foss Link ™ CC is in its final location
+ +
- -
© Danfoss 03/2014
™
HP kit is not
"OK"