Related Manuals for JETStream TREVI
Summary of Contents for JETStream TREVI
- Page 1 TRANSLATION OF INSTALLATION AND OPERATING INSTRUCTIONS PAGE 10-17 Read instructions! TREVI / TREVI LUX (230 V/ 400 V)
- Page 2 GB TRANSLATION OF INSTALLATION AND OPERATING INSTRUCTIONS TREVI, TREVI LUX (230 V/400 V) Preface This unit complies with the technical state of the art and is safe to operate. It was manufactured with great care and is subjected to regular quality checks.
-
Page 3: Safety Instructions
Attention! The JETSTREAM system forces up to 720 litres of water per minute into the pool through the nozzle. If all of this enormous force is used for massage, it can cause injuries to muscles and to connective tissue, as well as internal injuries. Because of the reduced electrical resistance of the human body in swimming pools and the resulting increased probability of the occurrence of dangerous currents in the body, increased safety requirements are imposed on the electrical installation. -
Page 4: Equipotential Bonding
Massage Hose (accessory, not included in the delivery) Switch the JETSTREAM unit off before you fit or remove the massage hose. Fit the massage hose onto the nozzle (2) and lock it in place with the sliding ring. To remove the massage hose, hold the hose tight in one hand and use the other hand to move the sliding ring towards the hose. - Page 5 1 (230 V) 1 (400 V) rubber buffer 55, min. 25, max. 80 rubber buffer 55, min. 25, max. 80 Measurements in mm Width of equipment 350 mm Measurements in mm Width of equipment 350 mm INSTRUCTIONS FOR AUTHORISED PERSONS INSTALLATION The unit may only be set-up by authorised persons.
- Page 6 2 (230 V) 2 (400 V) rubber buffer 55, min. 25, max. 80 Width of equipment 350 mm Measurements Measurements in mm Width of equipment 350 mm rubber buffer 55, min. 25, max. 80 in mm Installation in Overflow Pools (please unfold the last page, Fig. 2) With overflow troughs, uwe recommends mounting a brass intermediate frame (9).
-
Page 7: Electric Connection
The DIN VDE and applicable regulations for the prevention of accidents must be observed for all work with voltages. The unit is shipped with an 8 m (TREVI 230 V) or 10 m (TREVI 400 V) long, weather-resistant power supply cable and outlet box. For the power supply to the permanent connection, a cable cross-section of 3 G 2.5 mm2 (L,N,PE) for TREVI 230 V and H07 5 G 2.5 mm2 for TREVI 400 V is required,... -
Page 8: Setting Into Operation
Do not use abrasive cleaning agents! Replacement parts It may be used only original spare parts or parts which meet the specifications of the company uwe JetStream GmbH. A detailed list of spare parts is available from uwe JetStream GmbH upon request. -
Page 9: Technical Specifications
TECHNICAL SPECIFICATIONS CIRCUIT DIAGRAM FOR JETSTREAM TREVI, TREVI LUX Model(s) JetStream TREVI/TREVI LUX Typ 8203/2a/2aL JetStream TREVI/TREVI LUX Typ 8203/7a/7aL 9.1 With Single Phase Motor (TREVI 230 V) Mains 1 N 230 V AC 50 Hz Characteristics: 8203/7a/7aL 8203/2a2aL Power supply:...
Need help?
Do you have a question about the TREVI and is the answer not in the manual?
Questions and answers