Introduction This kit contains two 2.5” hard drives and mounting brackets for the RealPOS 70 /RealPOS 72 Installation Procedures Caution: Static Electricity Discharge may permanently damage your system. Discharge any static electricity build up in your body by touching your computer’s case for a few seconds.
Page 4
a. Insert the Security Key and turn it 90 degrees clockwise. b. Remove the Front Cover. Security Key Front Base Cover 26124 c. Pivot the top of the Front Base Cover toward the front of the unit and remove it from the terminal.
Page 5
d. Disconnect the Power Cord from the Power Supply. AC Power Cord 26135 2. The Dual Drive (RAID) system does not use the existing large format HDD. Squeeze the latch on the green Storage Media Bracket and pull the Hard Disk Drive out of the Base Chassis.
Page 6
3. Install the Primary HDD in the lower HDD slot. Primary Hard Disk Drive 26484 The Primary HDD connector (Drive 0) is the lower connector. The secondary is the upper connector. HDD/SSD Connector (Primary) Power Supply Connector 2nd HDD Connector I/O Board Connector Motherboard Connector 26043...
4. Install the Secondary HDD in the upper HDD slot. Secondary Hard Disk Drive 26485 5. Install the Front Base Cover and lock the Security Lock. RAID System If the secondary HDD is going to be used as a RAID volume see the RealPOS 70 User Guide (B005-0000-1872) for information about installing RAID.