Quoizel HGN9010WT Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses,
drill bit, center punch, hammer, drill and wrench.
Light Source: (1) A21 Medium Base Bulb 150W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Mounting Screw
A
x 3
Screw
B
x 2
Fixture Body
C
x 1
-
STEP 1 Remove Cage from the
Fixture Body
A. Unlock screws on the bracket and
remove the cage from the Fixture
Body (C).
Figure 1
but not included)
Figure 2
-
STEP 2 Install Bulb
A. Insert the bulb onto the socket
and screw snugly into place.
2019 QuoizelInc.
for product cleaning tips. Go to the
30-45 minutes
Glass Shade
D
x 1
C
Bracket
Vintage Bulb
(recommended
Socket
visit us on-line at www.quoizel.com
Installation Guide #IS-HGN9010WT
For Style HGN9010WT
Care + Maintenance selection.
-
STEP 3 Install Glass Shade
A. Remove the lock ball and flat
washer from the nipple in the top
center of the cage.
B. Place the Glass Shade (D) into
the cage and pass the center
hole on the top of the Glass
Shade (D) over the nipple in the
top center of the cage. Secure
Glass Shade (D) by threading
previously removed flat washer
and lock ball back onto the
nipple. Hand tighten until snug.
Cage
-
STEP 4 Install Cage with
Glass Shade
A. Place the cage with glass
Screw
shade onto the bracket and
secure with previously
removed screws. Hand
tighten until snug.
Figure 4
1of2
Nipple
Cage
D
Figure 3
Flat Washer
Lock Ball
C
ReleasedDate:2019-03-22
marking pen, 1/16"
Cage with
Glass Shade
Screw
Bracket