Download Print this page

Waylens Secure360 Installation Manual

Hide thumbs Also See for Secure360:

Table of Contents

Need help?

Do you have a question about the Secure360 and is the answer not in the manual?

Page 2 Secure360 4G Mount Plate & Adhesive Direct Wire...
Page 3 (4G Model Only)
Page 4 a. The constant power fuses are used to monitor constant power within a vehicle. They will not be switched off after you turn off the car. Identify them by referring to the vehicle manual or consulting a professional.
Page 5 The Secure360 should be mounted at the center bottom of the front windshield, optimizing visibility inside and outside the vehicle. NOTE: Do not place camera mount too low on windshield where visibility may be blocked by the vehicle itself, such as wiper blades or raised hood structures.
Page 6 1. With the Mount Plate attached to the windshield and the power cord connected to the Secure360, position the Secure360 on the right side of the Mount Plate. Next, ensure the Mount Plate locking tabs are aligned with their fittings 2.
Page 7 2. Slide the Secure360 Dock to the right and carefully pull the camera away from the Mount Plate once you feel it release from the locking tabs. Insert SD card with metal pins facing up. 3. Remove the power connection from the rear of the camera.
Page 8 This equipment should be installed and operated with a minimum distance of 20cm between the device and user. Automotive Security Camera The connected 360-degree dash camera that sees everything in and around your vehicle, even when parked PLUS live monitoring and notifications on your phone.