Advertisement
Quick Links
Covers all XYZ KMX Turret Mills
Copyright 2019, XYZ Machine Tools Ltd. All rights are reserved. No part of this publication may be reproduced,
stored in a retrieval system, or transmitted, in any form or by any means, mechanical, photocopying, recording or
otherwise, without the prior written permission of XYZ Machine Tools Ltd.
While every effort has been made to include all the information required for the purposes of this guide, XYZ Machine
Tools Ltd. assumes no responsibility for inaccuracies or omission and accepts no liability for damages resulting from
All brand names and products are trademarks or registered trademarks of their respective holders.
XYZ Machine Tools
ProtoTRAK
Safety and Quick Start Guide
the use of the information contained in this guide.
KMX CNC
®
Part Number:
Version:
XYZ Machine Tools Ltd.
Woodlands Business Park
Burlescombe, Tiverton, Devon EX16 7LL
T: 01823 674200 F: 01823 674201
www.xyzmachinetools.com
17640
180619
Advertisement
Summary of Contents for XYZ Machine Tools ProtoTRAK KMX CNC
- Page 1 T: 01823 674200 F: 01823 674201 www.xyzmachinetools.com Copyright 2019, XYZ Machine Tools Ltd. All rights are reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, mechanical, photocopying, recording or otherwise, without the prior written permission of XYZ Machine Tools Ltd.
- Page 2 Notes on the E-stop and Table Guard critical safety functions: • E-stop: • This is provided by a safety rated, hard-wired E-stop system controlled by the E-stop XYZ Machine Tools ProtoTRAK KMX CNC control, Safety and Quick Start Guide...
- Page 3 Before you clear away the Swarf, oil or coolant. Always use a chip scraper or brush. Before you make an adjustment to the part, vice, coolant nozzle or take measurements. XYZ Machine Tools ProtoTRAK KMX CNC control, Safety and Quick Start Guide...
-
Page 4: Operating Controls
Never change gears when the spindle is rotating • Stop and disconnect the power to the machine before undertaking any cleaning or maintenance Operating Controls Front of Pendant XYZ Machine Tools ProtoTRAK KMX CNC control, Safety and Quick Start Guide... - Page 5 20, continuous minutes, the LCD will turn itself off (black screen). Press any key to bring the screen back to its previous display. The key you press will be ignored, except to turn the screen on. XYZ Machine Tools ProtoTRAK KMX CNC control, Safety and Quick Start Guide...
- Page 6 AC SPDL EN: This connector is only used on some KMX, PT3 upgrades. It is internally connected to 110VAC in certain modes. DO NOT plug anything else into this connector. XYZ Machine Tools ProtoTRAK KMX CNC control, Safety and Quick Start Guide...
-
Page 7: Powering Up The System
The ProtoTRAK control should be shut off, at a minimum, every week. Failure to reboot may cause the control to run slowly. Maintenance Please refer to the schedule on the machine and in the service manual for important maintenance activity. XYZ Machine Tools ProtoTRAK KMX CNC control, Safety and Quick Start Guide... - Page 8 This machine is designed to cut common, metallic engineering materials (such as steel and aluminium). DO NOT use to cut special materials (such as composites or abrasives) without agreement from XYZ Machine Tools. Any damage caused to the machine by processing such materials will not be covered by the warranty.