State Water Heaters STATESMAN Premium Heavy Duty Specification Sheet

Premium Heavy Duty Electric Water Heater
I Limited Warranty Outline
– If the tank should leak any time during the first three years, under
the terms of the warranty. State Water Heaters will repair or replace
the heater; installation, labor, handling and local delivery extra.
– This Outline Is NOT A Warranty. For complete information, consult
the written warranty or State Water Heaters.
– Warranty does not apply to product installed out-side of the United
States of America or its territorial possessions and Canada.
COMMERCIAL 500 Lindahl Parkway, Ashland City, TN 37015 • www.stateind.com
®
The Expert's Choice
I
Meets or exceeds the requirements of ASHRAE/IES-90.1-1999.
I
ASME Tank Construction – 125 psi working pressure (65 thru 120
gallons), 150 psi working pressure (5 thru 50 gallons).
I Foam Insulated – To meet rigorous state codes.
I Glass-Lined Tank – Ten tank sizes available; 5 to 120 gallon. Tank
interior is coated with glass specifically developed for water heater
use. Tank cabinet has a baked enamel finish.
I Incoloy Immersion Heaters – Heavy-duty medium watt density
elements (three/immersion heater) have incoloy sheathing and
prewired leads: provide excellent protection against oxidation and
scaling. Input ranges from 3KW to 90KW available (see
accompanying chart).
I
Standard Voltages – 208, 240 and 480 volt single and three phase.
Single phase 208 and 240 are convertible to three phase. All 208 and
240 volt at 24KW and below are supplied phase convertible (single to
three and vice versa). 277 volt single phase also available. Consult
factory for 120 volt power circuit availability.
I Terminal Block – To accept copper or aluminum leads (on units with
more than one contactor).
I
Immersion Thermostat – Close differential immersion type
thermostat provides the accurate temperature control required for
commercial applications (adjustable through a range of 95° to 180°F).
I
120 Volt Control Circuit – 120 volt control circuit powered by fused
transformer.
I Magnetic Contactors – Heavy-duty UL rated for 100,000 cycles.
I Power Circuit Fusing (120 amp current draw and above) – Meets
National Electric Code and UL requirements that water heaters must
have internal fusing when current draw exceeds 120 amps.
I Other Standard Features
– Simplified circuitry, color-coded for ease of service
– Anode rod for corrosion protection
– Immersion manual reset high limit
– Brass drain valve
– Hinged control compartment door
– ASME T & P relief valve
I
Optional International Voltages - 380, 415, 575 and 600 volts
three-phase available with Y connected elements.