State Water Heaters SRGSS00905 Specification Sheet

S
ELECT
Residential Gas Water Heaters
State Select ® Power-Vent 40-gallon and 50-gallon gas water heaters now feature patented C3 Technology
Phase II of the ANSI Z21.10.1 standards for flammable vapor ignition resistance. A power-vent water heater is an excellent alternative
in many replacement applications where a conventional vertical-vent model is not a practical option and offers versatility for
placement of gas water heaters in residential new construction.
For Additional Technical Information,
PHONE 800-365-0024
STATE WATER HEATERS
500 Tennessee Waltz Parkway, Ashland City, TN 37015
www.statewaterheaters.com
POWER-VENT
®
Enhanced Power-Vent Capabilities
• For greater versatility than ever before, system allows combined horizontal
and vertical vent runs up to 120 equivalent feet with 3" pipe, up to 160
equivalent feet with 4" pipe on 40,000 BTU and 50,000 BTU models
• 40 and 50-gallon models vent using 2", 3" or 4" Schedule 40 PVC, CPVC
or ABS pipe
• Supplied with termination screens and elbow
• See next page for complete information on vent capabilities
Intelli-Vent ™ Electronic Gas Control
• Silicon nitride hot surface ignitor provides superior durability and eliminates
standing pilot
• Advanced circuitry ensures precise control of water temperature, provides
easy to understand system diagnostics
• Gas connection located on side of control, same as conventional gas control
Diffuser Dip Tube
• Reduces lime and sediment buildup, maximizes hot water output
• Made from State PEXAN
exposure to temperatures up to 400ºF
Patented Glass-Lined Tank with Aluminum Anode Rod
• For long-lasting protection against rust and corrosion
Advanced Power-Vent Blower Design
• Equipped with 110/120 volt electrical system (rating 3 amps or less),
6-foot cord with standard 3-prong male connector
• Patented design reduces NOx emissions up to 33%
• Complies with Southern California and Texas requirements
Durable Brass Tamper-Resistant Drain Valve
Factory-Installed Temperature & Pressure (T&P) Relief Valve
Design-Listed by Underwriters Laboratories
• Listed according to ANS Z21.10.1 or ANS Z21.10.3 standards
governing storage-type water heaters
• Additional code compliance: UBC, CEC, SBCC, CABO, HUD, BOCA
National codes, ASHRAE/IESNA 90.1-1999 and 2004 NAECA
Maximum Hydrostatic Working Pressure: 150 psi
C3 Technology ® Gas Water Heater Design – See other side
6-Year Limited Tank and Parts Warranty
• Consult written warranty or contact State Water Heaters for
complete information.
™ , a cross-linked polymer that can withstand long-term
® design, which meets
GAS-FIRED
GAS-FIRED
Page 1 of 2
SRGSS00905