Photo - Samsung ML-6060 Technical Instructions

4

Notes

Photo 17

Need trust-worthy, detailed Technical
Instructions for another engine?
Visit: www.futuregraphicsllc.com
E-mail: info@futuregraphicsllc.com
Photo 14
Photo 15
Photo 16
Photo 18
Photo 19
ML-6060/1650 Technical Instructions
Step 12
Rotate the cartridge 180°. Remove the
three screws that hold the contact end
cap to the cartridge. (See Photo 14)
Step 13
Slide the end cap from the side of the car-
tridge. (See Photo 15)
NOTE: A white bearing may be found on
the shaft of the supply roller. Remove the
bearing. (See Photo 16)
If the bearing is not present check the
cartridge end cap. (See Photo 17)
It is important that this bearing be present
during the reassembly of the cartridge.
Step 14
NOTE: On some cartridges the drum axle
can be removed at this time. Grab the
drum axle on the contact side and slide
the axle out of the cartridge.
(See Photo 18) If the axle cannot be
removed at this time continue to the next
step.
Step 15
Remove the two screws holding the waste
hopper to the cartridge. (See Photo #19)
Website: www.futuregraphicsllc.com