ActiGraph wGT3X-BT User Manual page 18

Red LED (Fault Indicator)
2 Flashes
3 Flashes
Green LED
1 Flash
Steady On
Red LED (Fault Indicator)
No Flashing
(LED Off)
2 Flashes
3 Flashes
Green LED
No Flashing
(LED Off)
1 Flash
2 Flashes
3 Flashes
Blue LED (Wireless Indicator)
-
1 Flash Every 3 Seconds
Note: The Red LED will ALWAYS flash to indicate LOW BATTERY regardless of whether "Flash Mode" is enabled or
disabled. If a "stop time" (optional) has been reached, the Green LED will stop flashing all together regardless of its
previous state.
49 E. Chase St.
Device Connected to PC
Battery is Faulty
A hardware failure occurred while recording data.
Contact customer support at
Battery Charging
Battery Fully Charged
Device Not Connected to PC
Normal operating condition or battery dead
Low Battery (use ActiLife Lifestyle software to check for remaining battery life). The
unit needs to be recharged.
- Unexpected Battery Failure (Temporary battery power loss)
or
- Battery Level has fallen below 3.1V and the unit has entered Halt Mode
Actively collecting data ("Flash Mode" disabled) or battery dead
- Delay before start mode (the LED always flashes prior to starting data collection)
-
Actively taking data ("Flash Mode" enabled – not recommended)
N/A
- End of memory reached (Device no longer collecting data)
-
Battery died while unit was in delay before start mode (no data collected on
device)
Wireless Feature Enabled
-
- Actively paired with and receiving Heart Rate data
- Actively paired and communicating with ActiLife or ActiLife Mobile
Table 7 – wGT3X-BT LED Reference Table
Pensacola, FL 32502
support@theactigraph.com
tel 850.332-7900
www.theactigraph.com
P a g e | 18
fax 850-332-7904