Installation - AEG ATB81121AW User Manual

12 www.aeg.com
Problem
Temperature cannot be set.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
Door does not open easily.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
7.2 Closing the door
1. Clean the door gaskets.

8. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
The FROSTMATIC function
is switched on.
The appliance is not level-
led.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FROSTMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.
You attempted to re-open
the door immediately after
closing.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
8.1 Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient
Solution
Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function"
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli-
ance.
Wait a few seconds between
closing and re-opening of
the door.