Table of Contents
Advertisement
Unlock the packaging locks:
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned Off.
2. Locate the battery cover on the bottom of the unit.
3. Use a screwdriver to loosen the screw and open the battery cover.
4. Remove old batteries by pulling up on one end of each
5. Install 2 new AA (AM-3/LR6) batteries into the battery
6. Replace the battery cover and tighten the screw to secure.
608300 manual.indd 4
Rotate the packaging locks 90
degrees counterclockwise.
Pull out the packaging locks.
battery.
box as illustrated. (The use of new alkaline batteries is
recommended for maximum performance.)
4
05/24/2019 09:45:01
Advertisement
Table of Contents
