Pioneer VSX-1018AH-K Service Manual page 66

1
A
[3] Error indications when an abnormality in the amplifier system is detected
[Purpose]
An error message is displayed when an abnormality in the amplifier system is detected.
[Error Messages]
FL Display
B
C
[Description]
AMP ERROR
D
AMP OVERHEAT : The temperature of the amplifier is
12V TRG ERR
HDMI NG
E
HDCP ERR
NOT SUPPORT : The output resolution is not correspond to the monitor at analog. –>HDMI(scaler exist)
USB ERROR1
[How to enter release mode]
Press and hold "STANDBY/ON" and "AUTO SURR" keys
on the front panel simultaneously for 2 seconds in standby mode.
F
66
1
2
Status
When AMP DC is detected
When a thermal shutdown (abnormal
temperature), etc. is detected
When the 12V trigger circuit is
short-circuited
When an error is detected during
communication with the HDMI microcomputer
When an HDCP ERR is detected.
When the monitor outputs a non
supported video format.
When the overload USB device(over 500mA)
is connected
: After a failure in the amplifier block or high DC output is detected, the shutdown process starts, then
the power will be shut off. Then the MCACC LED will flash. The power cannot be turned on again.
If you wish to turn on the unit after a shutdown activated by DC detection, enter DC detection
cancellation mode, by proceeding with the steps described in "How to enter release mode" below.
abnormally high.
: The 12V trigger output is short-circuited.
: There is no communication response from the HDMI u-com.
: The monitor is non-HDCP type or the monitor is standby state.
: The connected USB device is overload
2
3
Duration
(sec.)
Flashes 3 times.
Flashes 3 times.
Flashes
Flashes
Flashes 5 seconds.
Flashes
Flashes
After a failure is detected, the shutdown process starts,
then the power will be off. The power can be turned on
again in Normal mode.
VSX-LX51
3
4
4