Operating Your TCi-Timer
SEQUENCE # displays
the sequential order of
each recorded event.
ATHLETE #
displays the ath-
letes identifying
number.
SPLIT # displays which
split time is being
shown on the clock.
Sequence #
Sequence # is a chronological counter. (1 to
999, any sequence over 200 will not show the
first digit) It advances when the New button
is pressed, this helps the user keep track of
times when using Memory Review.
Power On/Off
To power up the TCi-Timer, press and hold
the Power On/Off button for 2 seconds. The
data from the last session is still in memory
until memory is cleared. The clock is now
ready to receive radio signals.
2
www.browertiming.com
SEGMENT displays
the time from split to
split.
SPLIT displays
the time from the
start to the split.
CUM displays the
cumulative (total) time
from the start to the
finish.
ON
OFF
Memory Clear
Press and hold both buttons at the same time
for approximately four seconds. Memory will
clear and the clock will be reset to Sequence
#1. **All past times will be lost.**
New Athlete
To start a new athlete, press the New button
and a reset clock is shown. If in Memory
Review, hold the New button to get to the
latest sequence to show a reset clock. (This is
the only time the Athlete # can be adjusted.)
The TCi-Smart Start will automatically start
a new athlete when in a mode that uses the
keypad.
Athlete # Adjust
Athletes can be assigned an identifying
number. Use Split/Scroll arrows to assign
an Athlete #. This may only be assigned
before the clock starts for that athlete. (If in
Memory Review, hold the NEW Button to
get to the latest sequence) After the desired
number is reached, the start will lock the
Athlete # to the time. If no adjustment is
made for the next athlete, the same Athlete
# will be assigned to the upcoming time.
Press and hold the buttons to engage a high
speed scroll.
The Athlete # entered into the TCi-Smart
Start keypad will override the number
entered in the TCi-Timer.
Clear
New
Split/Scroll
3
www.browertiming.com
Need help?
Do you have a question about the TCi-System and is the answer not in the manual?
Questions and answers