Table of Contents
Advertisement
WARNING!
Risk of personal injury or injury to others. All personnel must be fully trained and adhere to local and, where
applicable, site-specific health and safety laws and guidelines.
It is the responsibility of the local organizations to enforce safe working practices at all times.
WARNING! – EXPLOSION OR COMBUSTION RISK
Observe the requirements in the certificates and the precautions and special conditions of use documented in this
manual (refer to the Equipment Marking Information, section 4.5 on page 7).
The equipment may be opened only when it is de-energized or the area has been designated as 'safe' at that time.
WARNING! – ELECTRIC SHOCK
Only connect to an earthed supply. This unit is a Class 1 construction and must be connected to a Protective Earth
connection (GND).
WARNING! – ELECTRIC SHOCK
This product must be connected to a power supply of the same voltage (V) and frequency (Hz) as indicated on the
product rating plate and provided in the Technical Data section on page 24 of this manual.
A supply cable with adequate rating must be used. Temperature de-rating must be considered.
CAUTION!
Position the equipment to avoid excessive heat, vibration, humidity, and dust.
CAUTION!
Failure to service or maintain the product, fitting non-approved parts, or carrying out non-approved alterations or
servicing can be dangerous and could affect the safety of the product. It may also invalidate the terms and conditions
of the product warranty.
LIMITS OF USE
To achieve optimum performance and safe operation the equipment must be operated within the limits detailed in the Technical
Data section on page 24 of this manual. Operation outside these limits can result in damage to the equipment or failure to
achieve the performance specified.
Pollution Degree 2
This equipment is designed for operation in Pollution Degree 2 environments (non-conductive, transient pollution where
occasionally a temporary conductivity caused by condensation must be expected).
Overvoltage Category II
Overvoltage protection for CATII equipment or instruments intended to be supplied for wiring (applicable to both plug-connected
and permanently connected equipment).
ADDITIONAL INFORMATION
List of Abbreviations
The following abbreviations and terms are used in this manual:
ACRONYM
MEANING
BSPP
British standard pipe parallel (thread standard)
CCW
counter-clockwise (also anti-clockwise)
CW
clockwise
ESP
Electrostatic precipitator
SPCO
single pole, change-over (electrical switch)
Product Parts and Options
Please contact Goyen | Mecair or our local representative for more information on available spares kits, special tools, and
accessories for your instrument.
02
INSTALLATION AND OPERATION MANUAL – OWNER'S RECORD FFD MANUAL – FILTER FAILURE DETECTOR
Hide quick links:
Advertisement
Table of Contents
