Joy Sport HT-Excellent User Manual page 22

5 SEAT
First loosen the nuts which are fixed with the
seat (34) please refer to photo illustration 5-A.
Then slide the seat (34) on the seat group
(34). Tighten the loosen nuts.
Pull out the seat post knob (44) and hold on.
Insert the seat group (34) into the main frame.
Set it on your wanted position and release the
seat post knob. Screw it to firm. Please make
sure the seat post knob (44) must be inserted
through the holes inside the seat post and
screwed without any gap.
SEAT ADJUST
You can adjust your seat forward or backward.
Loosen the seat adjust knob (39) &
OD20*ID10.5*2.0T flat washer (38).
Then you can move the seat support (37)
forward or backward so that seat position could
be changed accordingly as your level. Finally
tighten the knob again. (Photo 5-B)
Photo 5-A
NUTS
15
16
17
18
16
30
41
42
41
14
Photo 6-A
40
37
38
39
6 METER POST
Remove the four M8*20 inner hexagon
screws (15), four M8 spring washers (16),
two M8 arc washers (17) and two
OD20*ID8.5*1.5T flat washers (18) which
are pre-assembled meter post.
Move the meter post housing (41) at upper
position of the meter post (14). Please refer
to the Photo 6-A. Then move the meter post
(14) close to the lower post. Combine the
meter connecting upper wire (30) with meter
connecting lower wire (42)
Then insert the meter post into lower post.
Lock them with the removed screws &
washers.
Finally fix the meter post housing on the main frame.
8
34
34
44
Photo 5-B