Drive Belts; Idle Speed - Check; Valve Clearance - Check And Adjust; Tire Condition - Inspect - Rayco RG13II Operator, Maintenance, & Parts Manual

Drive Belts

BEFORE BEGINNING TO CHECK OR ADJUST
THE BELT: SHUTDOWN THE MACHINE, ENSURE
THAT ALL MOVING PARTS HAVE COME TO A HALT,
REMOVE THE KEY FROM THE ENGINE START
SWITCH, AND PLACE THE KEY IN SAFEKEEPING.
EXTREME CAUTION MUST BE USED TO AVOID
DEATH OR SERIOUS INJURY. STAY CLEAR OF
BELTS AND CHAINS AND CUTTING WHEEL WHEN
THEY ARE MOVING!
To extend belt life proper tension must be
maintained. A loose belt will cause excessive
cutting wheel slippage and belt failure. A belt that
is too tight can cause bearing, shaft and belt
failure.
The cutting wheel is driven by the engine via a v-belt.
V-Belt Tension - Check
Drive belts are properly tensioned when 10 pounds of pressure
at the center of the span produces 5/32" deflection.
To adjust tension, loosen the engine mounting bolts, and
loosen the lock nut on
Air Cleaner Element - Service
Follow the directions found in the Honda Engine Operation
Manual.
Spark Plug - Check & Replace
Remove the spark plug and check condition and gap
(.028"-.031"). Follow the directions found in the Honda
Engine Manual.
Air Cleaner - Replace
Follow the directions found in the Honda Engine Operation
Manual.
Spark Plug - Replace
Follow the directions found in the Honda Engine Operation
Manual.
800.392.2686
NOTICE
RG13II Operation • Maintenance • Parts

Idle Speed - Check

Follow the directions found in the Honda Engine Operation
Manual.

Valve Clearance - Check and Adjust

Follow the directions found in the Honda Engine Operation
Manual.

Tire Condition - Inspect

Inspect tires and wheels for wear and damage.
Maintenance
33