Work Tool Options - Attachments; Sound Level Information; Vibration Data Information Concerning Hand/Arm Vibration Level; Guidelines For Reducing Vibration Levels On Equipment - Rayco RG13II Operator, Maintenance, & Parts Manual

• Surface material – Rocks and moisture of the surface
material may drastically affect the machine's traction and
machine's stability. Rocky surfaces may promote side
slipping of the machine.
• Slippage due to excessive loads – This may cause
downhill tracks or downhill tires to dig into the ground,
which will increase the angle of the machine.
• Width of tracks or tires – Narrower tracks or narrower
tires further increase the digging into the ground which
causes the machine to be less stable.
• Implements attached to the machine hitch or drawbar
– This may decrease the weight on the uphill tracks.
This may also decrease the weight on the uphill tires.
The decreased weight will cause the machine to be
less stable.
• Height of machine working load. When the working loads
are in higher positions, machine stability is reduced.
• Operated equipment – Be aware of performance
features of the equipment in operation and the effects
on machine stability.
• Operating techniques – Keep all attachments or pulled
loads low to the ground for optimum stability.
• Machine systems have limitations on slopes – Slopes can
affect the proper function and operation of the various
machine systems. These machine systems are needed
for machine control on slopes.
• Note: Safe operation on steep slopes may require special
machine maintenance. Excellent skill of the operator
and proper equipment for specific applications are
also required. Consult the Operation and Maintenance
Manual sections for the proper fluid level requirements
and intended machine use.

Work Tool options - Attachments

Only use work tools that are approved by Rayco for use on
Rayco machines. Refer to the Operation and Maintenance
Manual, Rayco options".
If you are in doubt about the compatibility of a particular work
tool with your machine, consult your Rayco dealer.
Make sure that all necessary guarding is in place on the host
machine and on the work tool.
Always wear protective glasses. Always wear the protective
equipment that is recommended in the work tool's operation
manual. Wear any other protective equipment that is required
for the operating environment.
To prevent personnel from being struck by flying objects,
ensure that all personnel are out of the work area.
While you are performing any maintenance, any testing, or
any adjustments to the machine, stay clear of the follow-
800.392.2686
RG13II Operation • Maintenance • Parts
ing areas: cutting edges, pinching surfaces, and crushing
surfaces.

Sound Level Information

The operator Equivalent Sound Pressure Level is used to
measure a work cycle sound exposure level
Hearing protection may be needed when the machine is
operated with an open operator station for extended periods
in a noisy environment. Hearing protection may be needed
when the machine is operated.
Vibration Data Information concerning
hand/arm vibration level
When the machine is operated according to the intended
use, the hand/arm vibration of this machine is rated by meter
per second squared.
Note: Vibration levels are influenced by many different
parameters listed below.
• Operator training, behavior, mode, and stress
• Job site organization, preparation, environment, weather
and material
• Machine type, attachments, and condition of the
equipment.
Guidelines for Reducing Vibration Levels
on Equipment
Properly adjust machines.
Operate machines smoothly. Maintain the conditions of the
terrain. The following guidelines can help reduce the whole
body vibration level:
1. Use the right type and size of machine, equipment, and
attachments.
2. Maintain machines according to the manufacturer's
recommendations.
a. Tire pressures
b. Brake and steering systems
c. Controls, hydraulic system and linkages
3. Keep the terrain in good condition.
a. Remove any large rocks or obstacles.
b. Fill any ditches and holes.
c. Provide machines and schedule time in order to
maintain the conditions of the terrain.
4. Use a seat that meets "ISO 7096". Keep the seat
maintained and adjusted.
a. Adjust the seat and suspension for the weight and
the size of the operator.
Safety
Properly maintain machines.
17