Advertisement
INSTALLATION INSTRUCTIONS
MODELS: CONTOUR 0036
ATTENTION
Please read all safety and assembly instructions prior to installation and keep for future reference.
1
Measure and Cut
W
3
Wall Structure
Wall Structure
The horizontal structure in between studs should be prepared by other
prior to the installation. The structure should be flushed to the studs and
should not be sticking out.
5
Prepare Dry-Wall
Prepare Dry-Wall
L x W
L x W
LED Linear
USA, Inc. | Edition: 13/09/2019 |
™
Width = 2.58"
Width = 2.58"
(66mm)
(66mm)
L
Measure and cut the mounting
profile to the desired length (L). The
width (W) of the mounting profile
is 2.58" (66mm).
Use the cut-out dimensions (LxW) defined by
the mounting profile (see instruction box #1).
Cut the 1/2" drywall to ensure the right fit.
LED LINEAR RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
2
Prepare Opening
Cut out or drill an opening at one or both ends of the mounting
profile per installation. This hole should be just enough to fit the low
voltage wires/connectors that will feed into the LED profile. Smooth
the edges of the opening to make sure the wires do not strip.
4
Install Profile
Install the mounting profile to the desired location by using the
appropriate screws provided by others.
6
Install Driver and Wires
Install Driver and Wires
Low voltage
plenum
rated wires
(by others)
Place the driver in a remote location and run the plenum rated low voltage wires
behind the wall and through the drywall sheet cut-out. Tape or tie a knot at the end
of the wire to ensure that the wires stay in place. Install the drywall on the studs.
3 (4)
Advertisement
