Page 1
The use of Glass Hatch Hooks with Upper straps will limit the load to 2 bikes only. Important warnIng t Is crItIcal that all yakIma racks and accessorIes be properly and securely attached to your vehIcle mproper attachment could result In an automobIle accIdent...
Yakima cannot warranty any installation onto any lIsteD as “no fIt”. vehicle that is not listed in the Yakima Fit List or Joe Fit Sheet. Rotate the uppeR fRame away position the fRames. fRom the loweR fRame.
Page 3
secuRe the fRame position. • turn and push the red triggers until they are seated in the hub. • move the frames apart very slightly until the red triggers Do not allow the frames snap. to move out of position. •...
Page 4
Do not attach the No glass or plastic? You won’t need the upper hooKs to glass glass hatch hooks, continue to step 13. or plastIc! Replacing uppeR stRap hooKs pull upper straps completely out of the bucKles. pass the strap ends through open the the hatch opening from hatch...
Page 5
If nOt attachIng upper hOOks tO glass Or plastIc, cOntInue here. adJust uppeR stRaps. position the frame as determined in step 6. the upper straps should hold the carrier in place. Adjust upper straps by pulling on the ends. (Loosen by pressing the metal buckles.) place loweR stRap hooKs.
Page 6
replacIng lower strap hooKs Remove the caRRieR fRom the caR. pull lower straps completely out of the hub. position the pads open the inside the trunk trunK Door. with the straps hanging free. before closIng the trunK: • ClOse the truNK. •...
Page 7
eXtend load aRms. replace reD trIggers. • make sure that both triggers on the inner hubs, are seated in the hub! pull and turn the • move both arms up and down, red triggers. they must snap into place! rotate load if the arms do not arms to snap into place,...