Getting Started - VTech Stack & Balance Teeter Totter Parents' Manual

GETTING STARTED

BATTERY INSTALLATION
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw.
3. Install 2 new AAA (AM-4/LR03)
battery following the diagram inside
the battery box. (The use of a new
alkaline battery is recommended for
maximum performance.)
4. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.
4