Power Cord - Telefunken TF-RS9200 Manual

Safety Precautions
Power Source
• Always use the provided AC adaptor.
• Operate only from the power source specified on
the AC adaptor.
• The power adaptor may become hot during normal
operation. This is not a malfunction.
• Please make sure that the adaptor is not covered
while in operation. Leave a space of 15 cm
(minimum) around the AC adaptor.
• The rating information and safety caution of the AC
adaptor are provided on the adaptor.
WARNING: When the set is not in use for a long time,
disconnect from the power.

Power Cord

• Do not place the unit, a piece of furniture, etc., on
the power cord, or pinch the cord.
• Handle the power cord by the plug. Do not pull out
the plug by tugging the cord and never touch the
power cord when your hands are wet as this could
cause a short circuit or electric shock.
• Never make a knot in the cord or tie it with other
cords. The power cords should be routed in such
a way that they are not likely to be stepped on. A
damaged power cord can cause fire or give you an
electrical shock.
• Check the power cord once in a while. When you
find it damaged, ask closest service agent for help.
• Please do not place the set in a place subject to direct
sun light, excessive dust or mechanical shock or in
a location near heat sources.
• The device should be placed on a solid and safe
base.
• Do not place the apparatus on a soft surface such
as a rug that might block the ventilation holes on
the bottom.
• A location should not be selected such as a room
with high humidity, as the condensation, arising in
the kitchen for example, may cause malfunction or
damage the device.
• Heating or other thermal radiation under the set
also may cause malfunction or damage the device.
• The hot air, which arises during the operation,
should be ventilated with sufficient air circulation.
Please do not put the device into closed areas and
do not cover it.
• Please avoid contact of the device with water or
humidity. Do not put into operation near bath,
swimming pools.
• Take care to provide good air circulation. Place the
device in a location with adequate ventilation to
prevent heat build-up in the device.
• Should any solid object or liquid fall into the cabinet,
unplug the device and have it checked by qualified
personnel before operating it any further.
• The device should not be exposed to dripping or
splashing and no objects filled with liquids, such as
vases, shall be placed on the device.
CAUTION
• Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
- 3 -